[Stc_cny] Got FrameMaker 7?

[rinch at Inficon.com]

Hi Everyone,

I've got three small FrameMaker files that I cannot open in FrameMaker 
6.0p405. I think they were created in FrameMaker 7.2, but I am not sure. I 
get the "it appears to be a FrameMaker document, it can't be opened with 
this release" error message.

Does anyone out there have FrameMaker 7.x? If yes, would you be willing to 
open the three files I have, and save them "down" to FrameMaker 6.0 for 
me?

Thanks!
Richard

******************************************************
Richard Inch
Technical Documentation Manager
Intelligent Sensor Solutions
INFICON
Two Technology Place
East Syracuse, NY 13057-9714
phone: +315.434.2507
fax: +315.437.3803
e-mail: richard.inch at inficon.com
http://www.inficon.com

******************************************************
NOTICE: - This message including any attachments is intended only for the 
use of the designated recipient(s) named above and may contain 
confidential information protected by law. If you are not the intended 
recipient, you are hereby notified that any disclosure, copying, 
distribution, or the taking of any action in reliance on the contents of 
this information is strictly prohibited. If you have received this 
transmission in error, please notify the sender immediately by e-mail and 
delete the original message including any attachments.
******************************************************